afx light CITYCOLOR400 Manuel D'utilisation page 6

TROUBLESHOOTING
Following are a few common problems that may occur during operation.Here are some sugges-
tions for easy troubleshooting:
1. The unit does not work,no light and the fan does not work
a. check the connection of power and main fuse.
b. Measure the mains voltage on the main connector.
c. Check the power on Led.
2. Not responding to DMX controller
a. DMX LED should be on. If not, check DMX connectors, cables to see if they link properly.
b. If the DMX LED is on and no response to the channel, check the address settings and DMX pola-
rity.
c. If you have intermittent DMX signal problems, check the pins on connectors or on PCB of the unit
or the previous one.
d. Try to use another DMX controller.
e. Check if the DMX cables run near or run alongside to high voltage cables that may cause damage
or interference to DMX interface circuit.
3. Some units don't respond to the controller
a. You may have a break in the DMX cabling. Check the LED for the response of the master/slave
mode signal.
b. Wrong DMX address of the unit. Set the proper address.
4. One of the channels is not working well
a. The stepper motor might be damaged or the cable connected to the PCB is broken.
b. The motor's drive IC on the PCB might be out of condition
5. FIXTURE CLEANING
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically
to optimize light output. Cleaning frequency depends on the environment in which the fixture
operates: damp, smoky or particularly dirty surrounding can cause greater accumulation of dirt
on the unit's optics.
a. Clean with soft cloth using normal glass cleaning fluid.
b. Always dry the parts carefully.
SPECIFICATIONS
Power supply ......................................................................................................................90-240V~ 50/60Hz
Consumption ............................................................................................................................................. 600W
Beam angle ..................................................................................................................................................... 35°
Photometric data ......................................................81500 Lux @ 1m, 12400 Lux @ 3m, 5020 Lux @ 5m
Light source ......................................................................................................... 60x 10W RGBW 4-in-1 LEDs
Protection class ............................................................................................................................................ IP65
Strobe/pulses .........................................................................................................................1-10 flashes/sec.
Dimensions ........................................................................................................................560 x 130 x 330mm
Weight ....................................................................................................................................................... 15.1kg
IMPORTANT NOTE: Electric products must not be put into household waste. Please bring them to a recycling centre.
Ask your local authorities or your dealer about the way to proceed.
EN 6 © Copyright LOTRONIC 2019