Husqvarna CRT900 Manuel De L'opérateur page 14

SERVICE AND ADJUSTMENTS
TO REMOVE BELT GUARD (See Fig. 21)
NOTE: For ease of removal, remove hairpin clip and clevis
pin from left wheel. Pull wheel out from tiller about 1 inch.
• Remove two (2) screws from side of belt guard.
• Remove hex nut and washer from bottom of belt guard
(located behind wheel).
• Pull belt guard out and away from unit.
• Replace belt guard by reversing above procedure.
TO REPLACE GROUND DRIVE BELT
(See Fig. 22)
• Remove belt guard (See "TO REMOVE BELT GUARD"
in this section of this manual).
• Remove old belt by slipping off engine pulley first then
remove from transmission pulley.
• Place new belt in groove of transmission pulley and
into engine pulley. BELT MUST BE IN GROOVE ON
ENGINE
PULLEY
PULLEY
CLEVIS PIN
HAIRPIN CLIP
Fig. 20
IDLER
TRANS MIS SION
PULLEY
BELT GUARD
SCREW
AND
WASHER
TOP OF IDLER PULLEY. NOTE POSITION OF BELT
TO GUIDES.
• Check belt adjustment as described below.
• Replace belt guard.
• Reposition wheel and replace clevis pin and hairpin
clip.
GROUND DRIVE BELT ADJUSTMENT
(See Fig. 22)
For proper belt tension, the extension spring should have
about 5/8 inch stretch when drive control bar is in "EN-
GAGED" position. This tension can be attained as follows:
• Loosen cable clip screw securing the drive control
cable.
• Slide cable forward for less tension and rearward for
more tension until about 5/8 inch stretch is obtained
while the drive control bar is engaged.
• Tighten cable clip screw securely.
EXTENSION SPRING
Fig. 22
14
SCREW
AND WASHER
HEX NUT
AND WASHER
(LOCATED
BEHIND
TIRE)
HAIRPIN CLIP AND
CLEVIS PIN
Fig. 21
CABLE CLIP
SCREW
DRIVE
CONTROL
CABLE
LESS
TEN SION
TEN SION
5/8"
MORE