Power Supply Mode - XciteRC X-PERT X90T Mode D'emploi

Power supply mode

Power Supply Mode
in this mode the charger provides an output power of 3 - 24 V DC for electronic equipment.
X-pert Charger X90T
The display shows the parameters which
you used last time. If you want to use these
settings again, press START for more than
2 seconds to activate the power supply
mode.
Or go to SETUP to config the settings.
Set maximum output current
Set maximum output power (W)
Displays actual output current
Displays actual output power (W)
Press Graph to view the actual current curve
This display shows the actual current
curve.
Press to go back to the Power Mode
display.
In the Power mode display, press STOP to
exit the power supply mode.
EN
33