Installation Instruction And Use; Installation And Use - Casselin CSM2B BLANC Mode D'emploi

DANGER ELECTRIC SHOCK!
- Don' t let the power supply cord touch hot parts
- Don't let the power supply cord along a table or a counter
- The appliance must be connected with a single-phase socket in conformity.
- Before any installation check all the electric cables or piping
WARNING !
Operating your appliance can reach very high temperature. To avoid injuries and
burns do not use the appliance if it is damaged. Do no use spare parts not
provided with your appliance
DANGER ELECTRIC SHOCK !
In the event of bad installation, the appliance can be dangerous and cause injuries. The
electrical safety of this appliance is ensured only if it is correctly connected to an
efficiently earthed system in accordance with electrical safety regulations. The appliance
must be unpacked entirely before the connection.

5.2 Installation and use

WARNING !
Installation and maintentenance must be only carried out by qualified technician.
Installation instructions and use :
- Unwrapped totally your appliance.
- Position the hand dryer as shown in the picture 1. Release gently the casing from
the back plate by removing the screws (5) with a screw driver.
- Fix the hand dryer approximately 1.3m from floor (min 0.90m max 1.30m) from the
air outlet.
- Using the template (picture 3) provided with the appliance, mark the positions for
the fixing holes. To conceal the mains power supply drill out the cable entry hole.
(picture 2)
- Using a drilling machine with a bit of 8mm, drill the fixing holes in order to place the
wall plugs and fixing screws.
- Insert the wall plugs so they are flush with the mounting surface. Then fix the back
plate with the fixing screws.(picture 2)
- Release the cable clamp, pierce the grommet cap and slide it over the cable end.
Bring the cable through the eyelet and connect the mains supply cable to the
18