Kroeplin F415 Mode D'emploi page 21

Function
Adjust digits
Quitting
adjustment
Adjustment of the tolerance limits in REL
Start SETUP
TOL
Adjust lower
tolerance limit
Adjust + / -
Select first digit
Adjust digits
Adjust upper
tolerance limit
Adjust + / -
Select first digit
Adjust digits
Quitting setting
Switching between MM / INCH
Start SETUP
UNIT
Select measuring
unit
hange measuring
unit
Basic Action
4x
2x
2x
2x
4x
3x
Result
Same procedure as in TOL LO
Attention!
TOL UP must be larger than TOL LO
Returning to the last selected measuring
mode
Example: 0,00 +/- 0,05 mm
SETUP Menu can be started within every
measuring mode
Lower tolerance limit
After short display TOL LO, the last
saved value will always be shown
Attention!
TOL LO must be lower than TOL UP
Same adjustment as per description ABS
After short display TOL UP, the last saved
value will always be shown
Attention!
TOL UP must be larger than TOL LO
Same adjustment as per description ABS
Returning to the last selected measuring
mode
SETUP Menu can be started within every
measuring mode
The last used measuring unit will be
shown
By pressing the MODE key again the
measuring unit MM will appear
21
Remarks