Publicité
Les langues disponibles
Les langues disponibles
USE & OPERATION (CONTINUED)
CONTROL PANEL (CONTINUED)
Timer Control
The dehumidifier can be set to automatically switch ON or OFF after a selected period of time (between
1-24 hour intervals). The Timer hours selection is displayed on the Timer/Temperature Display Screen.
NOTE: Before setting the Timer control, make sure there is power to the unit.
Auto-Off Timer:
While the unit is running, first press
you want the unit to run before it switches off. The unit automatically switches off after the set time
period has elapsed. You must repeat the Timer set up procedures to reset the Timer for next use, if
needed.
Auto-On Timer:
When unit is in standby mode, press
unit to automatically start running. The previous fan speed and humidity setting will be maintained. The
unit will continue running until the water tank is full (unless the unit is set up for continuous draining)or
until you switch it off manually.
NOTE: To cancel any Timer settings, simply press
display shows '0'.
Temperature / Timer Display
When the unit is switched ON, the Temperature / Timer Display shows the current room temperature.
Pressing the Timer
seconds, before reverting back to the temperature display
Humidity Control Setting
When the unit is switched ON, the Humidity Display shows the current humidity percentage. Press ▲ or
▼ to select your preferred humidity level. The humidity is adjusted in increments of 5% by pressing ▲ or
▼ . The adjustable Relative Humidity (RH) range is between 30% RH to 90% RH. Ten seconds after
setting the preferred humidity setting, the display will revert back to displaying the current humidity.
Recommended Settings: It is recommended to leave the unit running at 30% humidity at High Fan
Speed during the first 2 to 3 days until damp odors are removed. After a few days when the Relative
Humidity has been reduced to a more comfortable level, press ▲ or ▼ to choose a higher RH% that
maintains a comfortable humidity level thereafter. A recommended healthy humidity level is between
40% and 50%
°C/ °F Display Options
Press °C/ °F to change the Temperature Display from degrees Celcius °C to degrees Fahrenheit °F.
and then tap or hold the ▲ or ▼ to select the number of hours
and ▲ or ▼ to select the number of hours until you want the
temporarily switches the display to show the Timer setting (in hours) for 10
and then tap or hold the ▲ or ▼ until the Timer
EN
4
Publicité
