Allowed / Not Allowed Fuels - LA NORDICA FULVIA Manuel Utilisateur

Appliance categories
Fireplaces
Stoves
Cookers
Installation in premises with fire hazards is forbidden. Installation in residential premises in which, in any case, the depression
measured during installation between the internal and external environment is greater than 4 Pa - reference for Italy according to
standard UNI10683.
All national, regional, provincial and municipal laws and standards in force in the country where the appliance is installed must be complied
with.

ALLOWEd / NOT ALLOWEd FUELS

Allowed fuels are logs. Use exclusively dry logs (max. content of water 20%). Maximum 3 logs should be loaded. The pieces of wood should
have a length of ca. 20-30 cm and a maximum circumference of 30-35 cm.
Compressed not worked-out wood briquettes must be used carefully to avoid overheating that may damage the device, since these
have a very high calorific value.
The wood used as fuel must have a humidity content lower than the 20% and must be stored in a dry place. Humid wood tends to burn less
easily, since it is necessary a greater quantity of energy to let the existing water evaporate. Moreover, humid content involves the disadvantage
that, when temperature decreases, the water condensates earlier in the hearth and therefore in the stack causing a remarkable deposit of soot
with following possible risk of fire of the same.
Fresh wood contains about 60% of H
It is necessary to place this wood in a dry and ventilated place (for example under a roofing) for at least two years before using it.
Besides others, it is not possible to burn: carbon, cuttings, waste of bark and panels, humid wood or wood treated with paints, plastic
materials; in this case, the warranty on the device becomes void.
Paper and cardboard must be used only to light the fire.
The combustion of waste is FORBIddEN and would even damage the appliance and the flue, causing health damages and claims by the
neighborhood owing to the bad smell.
The wood is not a fuel which allows a continuous operation of the appliance, as consequence the heating all over the night is not possible.
Variety
Beech
Oak
Elm
Poplar
Larch*
Spruce*
Scots pine *
ATTENTION : the continuous and protracted use of aromatic wood (eucalyptus, myrtle etc.) quickly damages the cast iron
parts (cleavage) of the product.
The declared technical data have been achieved by burning beech wood class "A1" according to the requirement UNI EN ISO 17225-5 and
wood moisture content less than 20%. By burning a different kind of wood the efficiency of the product itself could change and some specific
adjustments on the appliance could be needed.
Reference standard net opening section with respect to
the appliance fumes outlet section
UNI EN 13229
UNI EN 13240
UNI EN 12815
O, therefore it is not suitable to be burnt.
2
kg/mc
* RESINOUS WOOD NOT SUITABLE FOR THE BURNING
Percentage of the
50%
50%
50%
750
900
640
470
660
450
550
ENGLISH
Minimum net opening value of
the ventilation duct
200 cm²
100 cm²
100 cm²
kWh/kg 20%
moistness
4,0
4,2
4,1
4,1
4,4
4,5
4,4
25