AEG HR 5626 Mode D'emploi page 48

English
48
Using the long hair cutting attachment:
Use the long hair cutting attachment to precisely cut the hair or beard.
• Use the slide control to release or retract the long hair cutting attachment.
Stop operation
Stop operation by pushing the switch downwards. OFF will be visible.
Cleaning and Maintenance
WARNING:
• Before cleaning the handset with water, disconnect it from the connection cable.
• Disconnect the mains adapter from the wall socket when cleaning.
• Do not immerse the parts into water.
CAUTION:
• Do not use a wire brush or other abrasives.
• Do not use sharp or abrasive cleaning agents.
Shaving head
You may clean the shaving head under running water.
1. Switch of the shaver.
2. Press the shaving head buttons.
3. Rinse the shaving head and the two cutting units under running hot water. Clean the
shaving head in soapy water once in a while.
4. Rinse thoroughly with clear water afterwards.
5. Let the cleaned parts dry.
Alternatively, clean the shaver with the brush provided.
CAUTION:
The shaving foil must not be cleaned with the brush.
• Use the brush to clean the cutter block and the inside of the shaving head.
Cleaning the hand-held unit and mains adapter
• You may wipe these parts with a damp cloth.
• Use slightly soapy water to remove spots.