Usage Recommendations - Indel Webasto Marine Isotherm DR16 Mode D'emploi

User Manual

2.2 Usage recommendations

• If possible, the refrigerator should be turned on for about 6 hours prior to
inserting the food items.
• Frequent opening of the refrigerator door will result in greater power
consumption.
• Ensuring adequate ventilation for the compressor and the condensing unit will
significantly reduce power consumption.
• Never obstruct the refrigerator's ventilation system.
• The electrical system must be kept in good condition. Inspect the batteries and
check the charge levels regularly. Always use a starter battery separate from the
motor.
• Keep the inside of the refrigerator clean and dry. Remove the condensation
water from the drip tray beneath the refrigerator's freezer compartment where
present.
• To keep the surface of the door in good conditions and intact, make sure that it
is always clean and dry.
• The unit has been designed with a product lock protection in the event of low
battery voltage. In the event of a compressor block, follow the instructions in
this manual and/or contact specialised technicians or Indel Webasto Marine Srl
service centres.
• The compressor can operate up to an angle of 30°, while greater angles can
cause permanent damage to the compressor.
45