Connections - Sharp PN-L703WA Manuel D'installation

Caution
• Be sure to turn off the main power switch and disconnect the plug from the power outlet before connecting/disconnecting
cables. Also, read the manual of the equipment to be connected.
• Be careful not to confuse the input terminal with the output terminal when connecting cables. Accidentally reversing cables
connected to the input and output terminals may cause malfunctions and the other problems.
1
2
For power outlet
TIPS
• Set the audio input terminal to be used in each input mode in AUDIO SELECT on the SETUP menu. The factory settings are
shown below.
Input mode Audio input terminal (Factory setting)
D-SUB1 Audio1 input terminal
D-SUB2 Audio2 input terminal
DisplayPort DisplayPort input terminal
HDMI1 HDMI 1 input terminal
• To use a touch panel with a computer connected to the video input terminal on this monitor, the touch panel and computer
must be connected, and Touch pen Management Tool and Pen Software must be installed on the computer from the supplied
CD-ROM.
When the Information Display Downloader is installed, you can check and download the most recent versions of the software
programs.
• To use a touch panel with a computer connected to the bottom, connect to the USB 1 port.
To use a touch panel with a computer connected to the side, connect to the USB 2 port.
(Factory setting. Can be changed in TOUCH INPUT SELECT in the SETUP menu.)
• Download the setup program for the SHARP Display Connect and Touch Viewer with the Information Display Downloader.
• To display a computer screen on the monitor by wireless, use MirrorOp for SHARP and the built-in Wireless controller.
In Wireless mode, a touch panel can be used even with a computer that does not have Touch pen Management Tool installed.
• To install and use the software, see the manual for each.
• The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks
of HDMI Licensing Administrator, Inc. in the United States and other countries.
• DisplayPort is a registered trademark of Video Electronics Standards Association.
• Adobe, Acrobat, and Acrobat Reader are either registered trademarks or trademarks of Adobe Systems Incorporated in the
United States and/or other countries.
• MirrorOp is a registered trademark of Awind, Inc.
• All other brand and product names are trademarks or registered trademarks of their respective holders.
8
E
3 4 5 6 7 8

Connections

19
20
21
13
14
15
16
17
18
9 10 11 12
Input mode
HDMI2
HDMI3
Direct Drawing Audio1 input terminal
Wireless
1. AC input terminal
2. Power cord (Supplied)
3. External speaker terminals
4. Audio output terminal
5. DisplayPort output terminal
6. Touch pen adapter port
7. USB 1 port (for touch panel)
8. LAN terminal
9. D-sub 1 input terminal
10. DisplayPort input terminal
11. HDMI 1 input terminal
12. Audio 1 input terminal
13. RS-232C input terminal
14. USB 2 port (for touch panel)
15. D-sub 2 input terminal
16. HDMI 2 input terminal
17. HDMI 3 input terminal
18. Audio 2 input terminal
Wireless controller terminals
19. Wireless adapter port
20. USB port
21. LAN terminal
Audio input terminal (Factory setting)
HDMI 2 input terminal
HDMI 3 input terminal
Wireless