Port Replicator Problems; Hard Drive Problems - Fujitsu LifeBook T900 Mode D'emploi

Problem
LifeBook Tablet PC fails to
recognize DVD/CD-
RW/CD-ROM's.
(continued)
Drive access indicator on
the Status Indicator Panel
blinks at regular intervals
with no disc in the tray or
the drive is not installed.

Port Replicator Problems

Note: Be sure to power down your LifeBook Tablet PC before adding a printer to the Port Replicator parallel port.
Tablet PC does not turn on
when installed in the
optional Port Replicator

Hard Drive Problems

You cannot access your
hard drive.
Possible Cause
Wrong drive designator was
used for the disc in the appli-
cation.
DVD/CD-RW/CD-ROM is dirty
or defective.
The Windows auto insertion
function is active and is
checking to see if a disc is
ready to run.
Port Replicator AC adapter is
not plugged in.
Tablet PC is not properly
seated in the Port Replicator.
The wrong drive designator
was used by an application
when a bootable disc was
used to start the Tablet PC.
Security is set so your operat-
ing system cannot be started
without a password.
104 - Troubleshooting
Possible Solutions
Verify the drive designator used by the application is the
same as the one used by the operating system. When the
operating system is booted from a DVD/CD, drive designa-
tions are automatically adjusted. Note that the drive designa-
tion can be changed with the Disk Management tool located
at Control Panel -> Administrative Tools -> Computer Man-
agement.
Wipe the disc with a non-abrasive CD cleaning cloth and
reinsert. If it still will not work try another DVD/CD-RW/CD-
ROM in the drive.
This is normal. However, you may disable this feature.
Provide power to the Port Replicator.
Remove and re-dock your LifeBook Tablet PC.
Verify drive designator used by application is in use by the
operating system. When the operating system is booted from
a CD, drive designations are automatically adjusted.
Verify your password and security settings.