Télécharger Imprimer la page

YBA HERITAGE A100 Mode D'emploi page 7

Publicité

Les langues disponibles

Les langues disponibles

Discovering your A100: Rear view
R
XLR
AUX
CD
DVD
L
R
1
2
CAUTION:
Before connecting or disconnecting any input or output:
Always make sure your A100 is in the OFF position. If you have any doubt, unplug the AC cable from
the power inlet.
Make sure all components connected to your amplifier are all set to off.
Neatly arrange and organize wiring to and from your A100 and to and from all your components.
Separate AC wires from audio cables to prevent hum or other unwanted noise from being introduced
into the system.
Balanced Audio input: This is a higher quality input that can reject noise and interference in the cable
1
when used with equipment with balanced outputs.
XLR connectors should be wired: Pin 1 - Ground; Pin 2 - Hot (in-phase); Pin 3 - Cold (phase-inverted).
2
RCA Audio inputs: Connect the RCA outputs of your source to the RCA inputs of your A100. Be sure to
connect the RIGHT output of your source to the R input of your amplifier and the LEFT output to the
L input of your amplifier. Your A100 allows the connection of 5 external, line level sources.
Note that the VIDEO input has a bypass feature. When you select VIDEO and then press < > OK in
sequence, the pre-amplifier is bypassed. By pressing < > OK in sequence once more the A100 returns
to its normal operating mode.
3
PRE 0UT: Pre-amplified output. If you want to use a subwoofer, a separate power amplifier or some
active speakers, use this connection.
Upgrade port: For service and future improvements. Not for use by end-users.
4
5
Right and Left speaker output: When connecting speakers take care to connect in phase. The + of your
speaker must be connected to the + of the A100. Connect your RIGHT speaker to the R output of your
A100 and the LEFT speaker to the L output. We recommend the use of banana plugs to prevent any
short-circuit. The A100 can be used with 8Ω or 4Ω speakers.
6
Power inlet: Use the mains cable provided with your A100. Be sure the switch is in OFF position
before plugging or unplugging the mains cable.
L
100
H e r i t a g e A
I N T E G R AT E D A M P L I F I E R
TUNER
VIDEO
PRE OUT
3
www.ybahifi.com
Heritage A100 Integrated Amplifier
R
L
UPGRADE
PORT
N
V
4
5
Designed in Paris, F rance
Hz
320
VA
6
Page 7

Publicité

loading