YBA HERITAGE A100 Mode D'emploi page 6

Heritage A100 Integrated Amplifier
Discovering your A100: Front view
Source
1
1 ON/OFF switch: Use this button to switch ON or switch OFF your A100.
2 Input selector: Selects between the six different inputs.
2
3
DISPLAY and IR sensor: All information relating to the operation of your A100 appears here.
Point the remote control to this zone to control your A100 from a distance.
4
Volume control: To adjust volume, set to zero upon installation.
0 0
P O W E R
1
2
2
3
4
5
6
Page 6
C D
2
Using your YBA remote control
Point your remote control to the IR receiver located in the display
window of your A100.
Select the device you want to control between AMP, CD and AUX. To
0
control the A100, you need to select AMP button.
Note: AMP will remain the active function until you select another
device.
1 SOURCE+/SOURCE-: Press SOURCE+/SOURCE- to skip to the desired
source.
2 VOLUME+/VOLUME-: Press + to increase volume, or - to decrease the
output volume of the amplifier. This is a universal control and does not
require specific source selection.
VIEW: Press to dim/brighten the display
3
4
FCT: Hold to store current volume level.
AUDIO: Press to resume to the stored volume level.
5
6
MUTE: Press to mute. Press again to exit mute.
Note:
PRESS means a short press on a key while HOLD means to keep the key
pressed for more than 3 seconds.
www.ybahifi.com
H e r i t a g e
48
100
A
3
Volume
4