Publicité
Les langues disponibles
Les langues disponibles
5.2. Automatic Bluetooth connection (after
successful pairing)
Note
• Make sure that your Bluetooth-capable terminal
device is on and Bluetooth is activated.
• For more information, please refer to the
operating instructions of your terminal device.
• Turn the hands-free set on as described in
5. Operation / Turning On.
• After the devices have been paired once, the
connection is then established automatically.
• You can now use the hands-free set.
Note
• If pairing was successful, the status LED (3)
flashes blue every 10 seconds.
• If pairing was not successful, the status LED
(3) flashes blue every 5 seconds, and you will
have to perform pairing again.
• It may be necessary to change the settings
on your terminal device to enable it to
automatically connect to the paired hands-
free set.
Note – Connection impaired
If the connection is interrupted, the status LED
(3) will flash twice in blue every 10 seconds. You
may only need to confirm the connection on your
terminal device.
After the headset and terminal device have been
paired, a connection is established automatically.
If the Bluetooth connection is not established
automatically, check the following:
• Check the Bluetooth settings of your terminal
device to see whether Avantree BTCK-10B is
connected. If not, repeat the steps listed under
5.1. Bluetooth pairing.
• Check whether obstacles are impairing the
range. If so, move the devices closer together.
• The performance can also be affected by a
weak battery.
5.3. Multipairing
• The BTCK-10B hands-free set can be paired with
two terminal devices at once so that, for example,
you can use a private and a business mobile
phone simultaneously.
• To activate the multi-pairing function, press and
hold the
-button (5) for approx. 3 seconds until
you hear a tone.
• To begin with, activate Bluetooth only on the first
terminal device that you wish to pair.
• Pair the first terminal device with the hands-free
set as described in 5.1. Bluetooth Pairing Setup.
• Turn the hands-free set off as described in 5.
Operation/Turning Off.
• Activate Bluetooth on the second terminal device.
• Press and hold the
approx. 7 seconds until the status LED (3) begins
to alternate red and blue. The hands-free set is
searching for a Bluetooth connection.
-multifunction button (7) for
5
Publicité
