Bartscher 500830 Mode D'emploi page 23

o Fill the water container with water up to the fill level as marked.
CAUTION!
Never use the device without water!
Ensure that the water level is not below the marking on the container.
Do not fill with too much water, as the food containers must be not allowed to float.
NOTE!
Fill the water containers with warm water, as this saves time and energy!
o Fill the suitable Gastronorm containers or soup pots with the desired warm food and
place them in the water container.
CAUTION!
Ensure that no liquids spill over while the device is in operation!
To avoid injury, do not overfill the food container!
o Connect the device to a suitable single mains socket.
CAUTION!
Always connect the mains cable to the socket on the device before connecting it to
the mains!
o The device is now ready to keep your food warm.
o Place the lid on the food container
o Switch the device on using the ON/OFF switch. The red power lamp on the switch
lights up.
o The temperature of the device can be adjusted using the temperature dial (levels 1-8).
The highest temperature can be reached by turning the temperature dial clockwise
to position 8. On this setting, the water in the water container is heated up to approx.
85 ° C. During heating the red heat indicator lamp n ext to the temperature dial lights
up. This goes out as soon as the set temperature has been reached. If the
temperature in the water container drops by around 10 ° C, the indicator lamp comes
back on and the water in the water container is heated back up to the set
temperature.
If the foods are to be kept at a lower temperature, select a setting below 8.
o
To do this, turn the temperature dial anti-clockwise.
The food in the Gastronorm containers/soup pots are kept warm by the heated
o
water in the water container.
To serve food from the container, remove the lid and place it on the lid holder.
o
- 22 -