Quadra-Fire 27I-ACC Manuel Du Propriétaire page 2

2700 Insert ACC
REMARQUE : Les dégagements ne peuvent être diminués que si
A. Exemple d'étiquette de numéro de série / de sécurité
EMPLACEMENT : Arrière de l'appareil
Numéro
du test du
laboratoire et
du rapport
2
et bienvenue dans la famille Quadra-Fire!
cela est autorisé par les autorités compétentes.
OWNER'S MANUAL
CAUTION:
HOT WHILE IN OPERATION DO NOT TOUCH, KEEP CHILDREN AND CLOTHING
AWAY. CONTACT MAY CAUSE SKIN BURNS.
KEEP FURNISHINGS AND OTHER
COMBUSTIBLE MATERIAL FAR AWAY FROM
THE APPLIANCE. SEE NAMEPLATE AND
INSTRUCTIONS.
LISTED ROOM HEATER, SOLID FUEL TYPE. "For Use with Solid Wood Fuel Only."
Also for use in Mobile Home.
Install and use only in accordance with manufacturer's installation, venting and operating instructions.
CONTACT YOUR LOCAL BUILDING OR FIRE OFFICIALS ABOUT RESTRICTIONS AND INSTALLATION INSPECTION IN YOUR AREA
Refer to manufacturer's instructions and local codes for precautions required for passing chimney through a combustible wall or ceiling.
WARNING - For Mobile Homes: Do not install in a sleeping room. An outside combustion air inlet must be provided and unrestricted
while unit is in use. The structural integrity of the mobile home floor, ceiling and walls must be maintained. The insert must be properly
grounded to the frame of the mobile home. A complete relining of the chimney system with a 6 inch (152mm) diameter listed stainless
liner is required. Must be equipped with a spark arrestor cap. Outside Air comes standard on the insert and must be installed before
operating insert.
When used as a masonry insert stove, install only in a masonry fireplace built to national and/or local codes. Do not remove brick or
mortar to accommodate insert. Installation requires a 5 foot minimum length of a starter pipe into existing chimney with airtight face seal.
Install only on a non-combustible hearth. Approved for installation and use in factory built zero-clearance fireplaces conforming to
minimum fire chamber specifications.
9.00 Components required for installation: positive or direct flue connection assembly or listed vent liner.
In Canada a full length 6 inch (152mm) S635 flue liner is required as per ULC S628-93.
WARNING - Inspect and clean chimney frequently. Under certain conditions of use, creosote buildup may occur rapidly.
Do not connect this unit to a chimney serving another appliance.
DANGER: Risk of electrical shock. Disconnect power supply before servicing. Route power cord away from unit. Do not route cord
under or in front of appliance.
Electrical Rating: 115 VAC .63 AMPS 60 Hz
Do not use grate or elevate fire. Build wood fire directly on firebrick. Do not overfire. If heater or chimney connector glows, you are overfiring.
Operate only with doors closed. Open only to add fuel to the fire.
Replace glass only with 5mm ceramic available from your dealer.
Maximum Mantel Depth - 10 inches (254mm)
Mantel
B
Fascia or Trim
C
A
Insert
E
F
Hearth Extension
Manufactured by:
352 Mountain House Road, Halifax, PA 17032
www.quadrafire.com
2016 2017 2018 Jan Feb Mar
U.S. ENVIRONMENTAL PROTECTION AGENCY - Certified to comply with 2015 particulate emission standards at 4.2 G/HR
EPA Method 28 and 5G. Not approved for sale after May 15, 2020. This wood heater needs periodic inspection and repair for
proper operation. Consult the owner's manual for further information. It is against federal regulations to operate this wood
heater in a manner inconsistent with the operating instructions in the owner's manual.
R
INSTALLATION MANUAL
Model: 2700-I ACC
WOOD INSERT
Report:
Tested and O-T L Portland
Listed by Oregon USA
#061-S-78-6.2
C US
OMNI-Test Laboratories, Inc.
TESTED TO:
UL 1482, ULC S628-93
HF
PREVENT HOUSE FIRES
Minimum Clearances To Combustible Material
Masonry, Heat Circulating & Zero Clearance
Refer to Clearances on reverse side for Canada
USA ONLY
A Sidewall to Stove
B Mantel to Stove
C Top Trim to Stove
D Side Trim to Stove
E Hearth Extension from Glass
D
Floor height 0 in. to 3-1/2 in. below insert base
Floor height greater than 3-1/2 in. below insert base 16 in.
F Hearth Extenson from Side of Insert
No Thermal Floor Protection Required in USA
Ember Floor Protection Required on All Installations
DO NOT REMOVE THIS LABEL
Apr May June July Aug Sept Oct. Nov. Dec.
FC7046-191H
Serial No. / N° de série
BARCODE LABEL
19-3/4 in.
21-1/2 in.
14 in.
13 in.
18 in.
8 in.
Made in U.S.A. of US and
imported parts.
7046-153_R5
Modèle
Numéro de série
Date de fabrication
13 Août, 2018