Publicité
Les langues disponibles
Les langues disponibles
C
•
onnect and disconnect charging plug to/from the booster only after removing AC cord
from electric outlet.
• Never pull on the AC cord to remove the AC plug from the mains. This may damage the cord
or the plug.
•Disconnect the charger before any cleaning or maintenance.
• If the charger has not gone to maintenance charging within 3 days, the charger and the
booster must be disconnected and verified by a qualified person. It may be that the booster's
batteries are sulfated.
2. Control Panel
START/STOP BUTTON
Press to immediately start charging your properly connected booster. If the button is not
pressed, charging should begin in ten minute's time.
POWER LED (green)
The charger is connected to an AC outlet.
Charging LED (yellow/orange)lit
The booster is charging.
Charging LED (yellow/orange) flashing
The booster is not charging because the charger has detected a problem.The "defect" LED will
also light up (refer to point 5 "Troubleshooting").
Charged/Maintaining LED – GREEN pulsing
The booster is fully charged. The charger gets in float charging mode to maintain the battery
capacity.
Battery Defect LED (red)
The charger has detected a problem with the booster battery. If might be damaged or
sulfated. In the above case, please contact your retailer (refer to point 5 "Troubleshooting").
Faulty Charging Circuit LED
The charging circuit is in reverse polarity, please contact your retailer.
865122-A-Manual-R0-20161010
Publicité
