Publicité
Operating Instructions
Replacing or realigning
the cutting head
1
Remove the end cap by pushing
it upwards
3
B
Slide new cutting head onto guide rail
A. Rubber wheel should sit on top
of the plastic pressure clamp
B. Blade should run alongside
the metal cutting edge
Warning
•
This is a 10-sheet (80gsm) trimmer. Do not overload!
•
Sharp blade - keep loose items and hands away
•
Suitable for trimming paper and light card only
•
Keep product out of reach of children
•
Never carry trimmer by the blade or guide rail
•
Do not immerse in water or other liquids
•
Never lubricate the cutting blade
•
Do not hang or wall-mount
•
Do not use outdoors
A
www.snopakebrands.com
2
2
1
Slide the guide rail through the
open end (1). You can now raise
the other end (2) to pull the
guide rail out completely
4
Replace guide rail and end cap
Do not touch the blade
✗
5
Publicité
