Signal Tones; Overheating Protection Facility; Rating Plate; Operation And Handing - Ellrona Comfort plus2000 SC Mode D'emploi

14.1.2

Signal Tones

14.1.3

Overheating Protection Facility

14.1.4

Rating plate

15 Operation and Handing

Ellrona Comfort plus 2000 SC
The appliance emits an acoustic signal after being switched on
and in the event of a fault.
The acoustic signal continues to sound until the fault has
been rectified or the appliance has been switched off.
You will find more detailed information on error messages in the
chapter entitled „7.2 Error Messages".
The appliance is equipped with an overheating protection
facility. If the temperature of the appliance exceeds the critical
limit the appropriate error message is displayed and an acoustic
signal sounds. For safety reasons the appliance shuts off
further power supply. After the cooling-down phase the
appliance can be switched off and then back on again.
The acoustic signal continues until the fault has been
rectified or the appliance has been switched off.
You will find more detailed information on error messages in the
chapter entitled „7.2 Error Messages".
The rating plate with the connection and performance data can
be founded on the back of the device.
This chapter provides you with important notices with regard to
operating the device. Observe the following notices to avoid
dangers and damages:
Do not leave the device unsupervised when it is in
operation, so that you can intervene quickly in the event of
dangers.
Operation and Handling
Please note
Warning
51