Intended Use - DeWalt DCW100 Guide D'utilisation

metal hydride or lithium ion batteries to an authorized D
service center or to your local retailer for recycling. You may also
contact your local recycling center for information on where to
drop off the spent battery.
RBRC™ is a registered trademark of the Rechargeable Battery
Recycling Corporation.
• An extension cord must have adequate wire size (AWG
or American Wire Gauge) for safety. The smaller the gauge
number of the wire, the greater the capacity of the cable, that
is 16 gauge has more capacity than 18 gauge. An undersized
cord will cause a drop in line voltage resulting in loss of power
and overheating. When using more than one extension to
make up the total length, be sure each individual extension
contains at least the minimum wire size. The following table
shows the correct size to use depending on cord length and
nameplate ampere rating. If in doubt, use the next heavier
gauge. The smaller the gauge number, the heavier the cord.
Minimum Gauge for Cord Sets
Volts Total Length of Cord in Feet
120 V 25 (7.6)
Ampere Rating
240 V 50
(15.2)
More Not
More
Than
Than
0 6 18
6 10 18
10 12 16
12 16 14
WALT
E
FEATURES (FIG. 1)
their accessories. Damage or personal injury could result.
WELDER COMPONENTS
A. (−) current socket
B. (+) current socket
C. Air filter
D. Charger socket connection
E. Carry strap
G. Grounding clamp
H. Setting value indicator
CHARGER COMPONENTS
R. Charger control panel
(meters)
S. Charger lead socket
50 100 150
(15.2) (30.5) (45.7)
100 200 300 U. Charging indicator
(30.5) (61.0) (91.4)

INTENDED USE

AWG
This portable welder is designed for professional STICK & TIG
welding applications.
16 16 14
16 14 12
16 14 12
12 Not
DO NOT use under wet conditions or in presence of flammable
Recommended
liquids or gases.
7
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
WARNING: Never modify any part of the welder, charger or
K. Process indicator
M. LCD setting value display
N. Status indicators
F. Electrode holder O. Setting value button
Q. On/off Button
I. Unit indicator
W. Completed indicator
T. Mains cable
V. Quick charging indicator
The device is intended solely for commercial use.
J. Batter capacity indicator
L. Welding process button
P. Adjusting dial
X. Error indicator
Y. Mains indicator
Z. Quick charge button