Publicité
Les langues disponibles
Les langues disponibles
INSTALLING OR REMOVING BATTERY PACK
TO REMOVE BATTERY PACK: Depress the battery pack release button (7) and pull
the battery pack (8) out of tool.
TO INSTALL BATTERY PACK: Push the battery pack (8) onto tool until it locks in
place.
INSTALLING BITS
Always follow the procedure below to install a bit.
1.
Pull the guide sleeve (2) forward.
2.
Insert the bit into the hexagonal hole.
3.
By releasing the guide sleeve it will return to its original position.
REMOVING BITS
Always follow the procedure below to remove a bit.
1.
Pull the guide sleeve (2) forward.
2.
Take the bit out from the hexagonal hole.
3.
By releasing the guide sleeve it will return to its original position.
CAUTION
NOTE
Always check the direction of the rotation before use.
Operation as a Drill:
Low voltage due to a nearly discharged battery will reduce the fastening torque Rotate
Torque Adjustment Collar to Drill Position. Install and tighten the desired drill bit in
the hexagonal hole. Select the desired torque range to match the torque to the planned
operation, and then drill it. Follow these instructions for best results when drilling.
Drilling:
Use sharp drill bits only. For WOOD, use twist drill bits, spade bits, power auger bits,
or hole saws. For METAL, use steel twist drill bits, or hole saws. For MASONRY,
such as brick, cement, cinder block, etc., use carbide-tipped bits. Be sure the material
to be drilled is anchored or clamped firmly. If drilling thin material, use a "back-up"
block of material so not to damage to the material. Always apply pressure in a straight
line with the bit. Uses enough pressure to keep the drill biting, but do not push too
hard or this may cause the motor to stall or defect the bit.
Hold the tool firmly to control the twisting of the drill.
1English1
ASSEMBLY
Always set switch (5) to off position when installing and
removing socket.
OPERATION
English
-8
Publicité
