Publicité
Les langues disponibles
Les langues disponibles
DE GB NL FR
3.
User MAnUAl
Do not switch on the device if there is a chance the water insi-
de the device is frozen.
Make sure the pressure of your water supply system supersedes the 0,5bar
(0,05MPa).
Setting the desired water temperature
Step 1: When the power is turned on for the first time, or if the power has been
switched off, the appliance requires about 15 seconds to start up.
Step 2: Open one of the hot water taps connected to the system and press ■
to illuminate the display. Press ■ again to switch on the appliance. The set tem-
perature will be displayed for 2 seconds. Then the display switches to the actual
temperature of the running water.
Step 3: To increase the temperature: open one of the hot water taps connected
to the system and press ▶. The temperature can be reduced by pressing ◀. The
set temperature is displayed for 2 seconds. Then the display switches to the actual
temperature of the running water.
After this, the appliance will automatically switch on each time a water tap is
opened. The temperature of the running water appears on the display. When the
tap is closed, the display switches off after 3 seconds.
The appliance can be installed with the inlet and outlet at the top or at the bottom.
If the controls and temperature indication are displayed upside down, switch off
the power briefly. The display will correct itself when you switch on the power
again. The appliance will require about 15 seconds to start up again.
If the set temperature is not reached, adjust the water flow rate.
C. Adjusting the water flow rate.
Step 1: Press down on the ribbed area of the cover and move it towards the wall.
Step 2: Apply pressure to the rear of the cover until the front lifts.
Step 3: Now remove the cover by pulling it forwards.
Step 4: Adjust the screw to the desired setting. T urn it clockwise for maximum
water flow. T urn it anticlockwise to reduce the water flow.
20
Publicité
