Publicité
Les langues disponibles
Les langues disponibles
b) First starting:
Before the first use, remove the anti-corrosion protection fat with a cleaner and a wet
sponge.
During the first use, grease your plate with oil and preheat the crepe machine during
about 15 min. Once preheating is finished, set the thermostat on the wished tempera-
ture.
First cleaning
Clean the device before the first use. (See 6. Cleaning)
Connection of the device
- Check that the tension and the frequency of the electricity network suit to the values
indicated on the descriptive plate.
- Make sure that every control knob is positioned on 0.
- Check that neither the cord nor the plug are damaged
- Unwind completely the electric power cable and connect it in a plug connected with the
earth.
- The device is connected.
NB: in case of connection of the device in a plug without earth protection or directly on
the electricity network, confide its connection to a qualified person .
c) Use of device :
Elements of command and display
Command/Display
Thermostat (n°2 on picture)
Orange pilot light
(n°1 on picture)
Putting on
Turn on the thermostat control knob (n°2 on picture) on the wished position: the
orange pilot light (n°1 on picture) ignites. The machine is warming up. Once orange
pilot light (n°1 on picture) is off, the machine reached the wished temperature.
Grease the plate before each cooking.
Temperature setting
Set the temperature by positioning the thermostat (n°2 on picture) to the desired
temperature. The orange pilot light (n°1 on picture) switches on if a higher level of
temperature is required and switches off when the same is reached.
It is not necessary to leave the device switched on at full power. It is necessary to
adapt the temperature to products to be cooked to limit the energy consumption.
Function
On/off + Temperature setting
Machine is heating (pilot light on)
Temperature reached (pilot light off)
13
Publicité
