Features & Controls; Icon Touch Controls - Zephyr Modena ZMO-E30BS Guide D'utilisation, D'entretien Et D'installation

ZEPHYRONLINE.COM

ICON Touch Controls

Power / Delay Off
1 POWER / DELAY OFF BUTTON
Power Button Function
- Button will turn power on and off for entire hood (fan and lights).
- Hood will remember the last speed and light level it was turned off at.
(Example: Press
Press Button again and the hood will turn back on at speed 4 and high lights
level.)
Delay Off Button Function
- With the fan on press and hold the
to speed 1 and the 5 minute delay off timer will start.
+
accordance with the time remaining until the fan and lights automatically turn
off.
- Pressing Button while Delay Off Function is enabled will turn the hood off and
cancel the Delay Off Function.
ACT™ Verification
- Airflow Control Technology (ACT™) allows the installer to set the maximum fan
CFM to align with local codes and regulations.
- To verify the maximum fan CFM:
- With hood off, hold the
indicators illuminate = default maximum CFM. If four fan speed indicators
illuminate = 390 maximum CFM. If 3 fan speed indicators illuminate = 290
maximum CFM.
2 SPEED SELECTION BUTTON
Fan Speed Decrease Button
- Press this button to decrease fan speed. 5, 4, 3, 2, 1.
- If fan is On Speed 1 and this button is pressed, fan will power Off.
Fan Speed Increase Button
- Press this button to increase fan speed. Fan On, 1, 2, 3, 4, 5.
- If hood is Off and this button is pressed, fan will turn On Speed 1.
ACT™ Enabled Speed Selections
- When ACT™ is enabled, the number of fan speeds will be reduced as follows:
- 390 CFM = Maximum 4 speeds
- 290 CFM = Maximum 3 speeds
Modena Use, Care, and Installation Guide
Adjust 5 Speed Levels
Display (speed level, delay off, filter clean/change)
Button to turn off hood when on fan speed 4 and high lights.
Button for two seconds. The fan will change
LEDs will illuminate and slowly blink in
Button for two seconds. If all five fan speed
Features & Controls
Lights Low/High/Off
21