Greencut JET200L Manuel D'utilisation page 49

1. Attach the short lance to the power nozzle. When attaching, align the two projections.
Two projections of the lance with the slots of the power nozzle, as shown in the picture.
2. Fitting the multi-spray nozzle. When fitting, turn the nozzle left and right to ensure that the nozzle is fully seated
in position and pull gently to ensure that it is locked in position.
WORKING MODE 2:
In this working mode, the highest pressure is 320 psi. It is suitable for heavy stain removal.
1. Attaching the extension lance to the power nozzle.
2. Attaching the short lance to the extension lance.
NOTE: When attaching, align the two projections on the lance with the slots on the power nozzle as
shown in the pictures. After attaching the hose, check the connection by pulling it very gently. Note
that it must not be pulled tightly or out of the check.
49
EN