EIBENSTOCK EBS 180 F Notice Originale page 21

Overload Protection
In order to protect the operator, motor and drill bit, the concrete grinder is
equipped with an electronic and thermal overload protection.
Thermal: In case of permanent overload, a thermocouple protects
the motor against destruction. In this case, the tool
switches off automatically and can only be restarted after a
certain cooling period (approx. 2 minutes). The cooling
period depends on the heating of the motor winding and
the ambient temperature.
Electronic: In case of overload, the electronic facility will deenergize
the tool. After discharge and reengagement one can drill
again.
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an
electric specialist.
Due to its design, the machine needs a minimum of care and maintenance.
However, the following points always have to be observed:
Always keep the power tool and the ventilation slots clean.
During work, please pay attention that no particles get inside the
machine.
In case of failure, a repair has to be carried out by an authorised
service workshop.
Our after-sales service responds to your questions concerning
maintenance and repair of your product as well as spare parts.
EIBENSTOCK's application service team will gladly answer questions
concerning our products and their accessories.
Environmental Protection
Raw material recycling instead of waste disposal
To avoid damages on transportation, the power tool has to be delivered in
a sturdy packing. Packaging as well as unit and accessories are made of
recyclable materials and can be disposed accordingly.
The tool's plastic components are marked according to their material,
which makes it possible to remove environmental friendly and
differentiated because of available collection facilities.
21