Philips HC5440/80 Mode D'emploi page 11

5 Clean the cutting unit with the brush or rinse it under the tap.
6 Clean the inside of the appliance with the brush.
Never immerse the appliance in water or rinse it under the tap.
7 Shake off excess water. To reattach the cutting unit, insert the lug of
the cutting unit into the guiding slot.
8 Insert the lug of the cutting unit into the guiding slot (1) and push
the cutting unit back onto the appliance (2).
Replacement
Only replace a worn or damaged cutting unit with an original Philips cutting
unit, available from authorised Philips service centres.
1 Press the release button (1). The cutting unit comes off the appliance
(2).
2 Insert the lug of the new cutting unit into the guiding slot (1) and
push the cutting unit back onto the appliance (2).
ENGLISH
11