Publicité
Les langues disponibles
Les langues disponibles
E N
T E M PE R AT U R E
Press
to adjust the temperature.
•
Digital display shows the temperature setting 23
with 14 settings cycle from "OFF", "16
•
The TEMP will increase by 1
•
By pressing the TEMP for 3
and °F.
TI M E R
Press the button
to 9 hours.
M O O D LI G H T
Press the button
R E S E T TI N G T H E T H E R M A L C U T O U T
The appliance is fitted with an Electronic Safety Control (E.S.). This is a
safety device, which switches off the fire if, for any reason, the appliance over-
heats, e.g. when covered. If the heater stops operating while the flame effect
continues working normally, this indicates that the E.S. Control is in operation.
The E.S. Control can only be re -set after the appliance has cooled down,
and the appliance has been reset. Re -setting of the E.S. Control proceeds is
as follows:
1.
Switch off the appliance (Manual On
approximately 10 – 15 minutes.
2.
Remove any obstruction to the fan heater outlet or fan blades etc.
Make sure that the power supply is disconnected with the plug socket
outlet while doing this.
3.
Switch on the appliance and the E.S. Control will be re -set.
4.
Ensure that the appliance is functioning correctly. If the E.S. Control
doesn' t operates again, the appliance should be checked by a
competent electrician.
28
°C up to 28
s, the digital display can show between °C
to switch between the OFF settings and 0.5 hours
to switch between 14 effects, including the Off setting.
°C (default setting),
°C" to "28
°C".
°C when pressed each time.
/
Off switch) and leave it off for
Publicité
