Publicité
Les langues disponibles
Les langues disponibles
- en -
Dear customer
Thank you very much for choosing a weka product.
•
Read these instructions through completely before assembling your product in order to avoid errors in
assembly or damage.
•
IMPORTANT
Please use the enclosed packing list to check immediately that your weka product has been
delivered complete and intact.
•
Please do not dispose of the packing list before the guarantee period has expired. This list enables you
to check that all the individual parts are present. It should be retained along with the proof of purchase.
Any complaints which may arise can probably be easily rectified with this list. The item numbers on the
packing list do not correspond to the item numbers in the following assembly instructions.
•
We recommend that 2 people carry out the assembly.
•
In order to prevent accidents, we recommend that children are kept out of the direct vicinity during
assembly.
•
We reserve the right to make further technological developments. This means that there many be minor
deviations in the illustrations.
•
Please do not simply throw away the packaging material. Paper, card and corrugated board as well as
plastic packaging materials should be placed in the correct collection containers.
RECOMMENDATIONS
•
Please drill pilot holes for all screw connections to avoid damaging the wood. The following symbol in the
instructions will indicate when this is necessary:
•
Protect the wood from hours of direct sunlight and moisture.
•
Wood is a natural product. Fluctuations in colour, knots and cracks are normal and have no influence on
the statics.
•
A prerequisite for successful assembly, is the anchoring of the studs in the concrete foundation using H
stud supports. The stud supports are available as weka accessories for an additional cost.
•
A foundation plan can be obtained from your specialist dealer!
•
In order to facilitate the precise alignment of the H anchors, mark the necessary post clearances on a
piece of guide wood and fix the anchors in place with screw clamps.
•
Then suspend the H anchors in the base holes already prepared.
•
The required roof pitch of 2% (gradient towards the rear) can be achieved by varying the height of the
stud supports.
•
The required gradient can also be achieved by shortening the studs.
•
After the holes have been filled with C25/30 concrete, the foundation must be allowed to set for at least 3
days.
•
The maximum snow load for this carport is 3,0 kN/m², resulting in a maximum permissible snow depth of
1,50 m. If the snow depth exceeds this amount, the roof must be cleared.
Warranty terms of weka Holzbau GmbH
We guarantee the function of our products for 5 years from the date of delivery based on the following
conditions – however only on the wooden parts of our products (hereinafter weka product) and not on
connected components or parts of the weka product made of another material besides wood. Within the
warranty period defective parts or missing parts of the product or the product itself will be replaced at our
discretion. The warranty extends only to the free-of-charge replacement of the respective faulty or defective
wooden part. The warranty does not cover any consequential or additional costs, in particular no delivery and
installation or modification costs.
Techn. Änderungen vorbehalten!
+
Alle Maßangaben sind ca. Maße.
4
Copyright HRB 3662
Publicité
