Operating Conditions; Protection Devices - Bevel Tools Bevel Mate EBA 3.0 Mode D'emploi

The specified vibration value was measured with a standardized test procedure. It can be used to compare products or
to make an initial assessment of the exposure. The vibration emissions may differ from the specified value, depending
on how the power tool is used. Operating personnel must be protected with defined safety measures based on the
estimated exposure under the actual conditions of use (these must take into account all phases of the operating
cycle, e.g. the times when the power tool is switched OFF and the times it is switched ON, but is not under load).

2.4 Operating conditions

Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
3.1 Protective devices
The machine may only be operated with the flange head and the additional handle fitted!
3.1.1 Flange head
i Adapt flange head
• Turn the flange head until it has reached the right depth.
• Rotate the guide plate until the required bevel height has been set as shown by the fixed main scale.
Cleaning depth mechanism
• Remove guide bearing and bevel head.
• Turn the flange head until it comes off.
• Clean all parts and replace defective parts.
• Lubricate the thread with Teflon spray and gears with a little multi-purpose grease.
• Re-assemble in reverse order.
3.1.2 Additional handle
The additional handle must be screwed in at the left and right with the supplied screws.
3.1.3 ON/OFF switch
Two-pole ON/OFF switch with turn-on inhibit and locking.
3.1.4 Protection of the machine
• Starting current limitation. The electronically controlled soft starting provides for smooth starting of the machine.
Due to the low machine starting current a 16A fuse is adequate.
• Temperature-dependent overload protection. For protection against overheating, when a critical temperature is
reached, the electronic safety feature switches into the cool down mode. Then the machine continues to run at
approx.: 3.200 rpm and the electronic constant speed control is deactivated. After a cool-down time of approx.
10 - 20 sec. the machine is again ready for operation. Turn the machine off and back on again to activate the
electronic constant speed control. When the machine is at operating temperature the temperature-dependent
overload protection reacts correspondingly earlier time.
• Overvoltage/restarting protection. On short-time outage of the power voltage (pulled power connector, unstable
power voltage etc.) the machine will stop. On recovery of the power voltage the machine has to be turned off and
back on again. The machine is then ready for operation.
EN
4