Maintenance; Troubleshooting - Greencut GTC1200C Manuel D'utilisation

48

MAINTENANCE

Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION: Make sure the machine is completely turned off before performing any maintenance
or repairs. This will eliminate any potential risk.
The machine is set at the factory. Do not make unnecessary adjustments, adjust only when necessary
due to normal wear.
CLEANING GUIDELINES
ATTENTION: Do not use solvents, chemicals or abrasives when cleaning the machine, as some
surfaces may be damaged.
• Clean the bottom of the housing around the burs and the protective shield and wing with a scrubbing brush, and
a soft brush or cloth moistened with a mild soap and water mixture.
• To remove soil and debris from the strawberries and the transmission, use a hard brush or a damp cloth.
• Clean the fan and remove any grass or dirt.
• After cleaning, wipe the burs and shaft, dry them and apply a light coat of oil.

TROUBLESHOOTING

The table includes some of the most common problems, their causes and remedies.
PROBLEM
The engine does not start
Abnormal vibrations
Poor tillage
POSSIBLE CAUSE
No electricity
Defective cable
Defective switch
Overheating protection activated
Damaged or worn blades
The working depth is too great
The working depth is too small
Worn blades
SOLUTION
Check the connection to the power supply.
Check the cable and take it to an authorised
service centre for replacement if necessary.
Have it repaired in a specialist workshop.
-Too much working depth, adjust to a shorter
depth.
- The blades are blocked, unblock the cutters.
-Terrain too hard, forward and backward
several times while slowly slowing down.
Replace it or have it checked by a specialist
workshop.
Adjust it to correct the working depth.
Adjust the working depth.
Replace the blades.