Panasonic AJ-P2C004HG Mode D'emploi page 2

ENGLISH
･ To avoid fire, electric shock, damage
or malfunction to your equipment, do
not disassemble or remodel.
･ Immediately stop using the card if
you notice smoke, strange smells or
sounds, or if liquid gets into the card.
Features
This memory card is suitable for use in
P2 series products, such as memory
card cameras/recorders, memory card
recorders, and memory card drives, and
that complies with the CardBus standard.
Supplied accessories A
(b) 1 Cap (part number: VMG1632)
(c) 1 Case (part number: VFC4069)
Preparations
Install the card's driver software before
using this card in a memory card drive or
computer. This software is included with
the P2 series recording equipment. Please
read its operating instructions for details.
Handling and storage
precautions
• To avoid fire, electric shock, damage
or malfunction to your equipment, do
not impact, bend, drop, or wet.
• After removing the card from equipment,
immediately attach the cap to it to
protect its terminals from dust and grime.
When storing the card or carrying it
around, keep it in its protective case.
• Do not leave the card where it may be
exposed to corrosive gases.
• While data is being read or written, do
not remove the card or turn off any
equipment using the card. Do not
remove the batteries from battery
operated equipment. These actions
can cause loss or corruption of the
data. If this does happen during
writing, read the instructions for the
equipment as it may be possible to
retrieve the data.
• Make backup copies of your data
wherever possible. Panasonic will not
accept responsibility for any data loss
or loss directly or indirectly caused by
data loss.
How to remove the card
from its case
A
1 Release the lock in area (a).
2 Open the case.
• While removing the card, hold the case
in the direction shown in the figure so
that the card will not fall onto the floor
or ground.
• To avoid damaging the case, do not
attempt to open it by holding area (a).
3 Remove the card.
• To remove only the card, slide it in
direction (d).
• To remove the card with the cap,
remove it in direction (e) while at the
same time pushing it in the cap direction.
Model
DVCPRO,
2-channel audio
AJ-P2C004HG 16 minutes
AJ-P2C008HG
32 minutes
･ Total card capacity includes space for
data management such as system data,
therefore, actual usable area is less
than capacity indicated on the card.
If using AJ-P2C008HG:
To use the AJ-P2C008HG, a P2 card driver must be installed on your P2
series product. For the latest information on drivers, visit the P2 Support
Desk at the following Web sites.
In Japanese: http://panasonic.biz/sav/
In English: https://eww.pavc.panasonic.co.jp/pro-av/
Parts and their functions B
(f) Serial number
(g) Write-protect switch
• Switch to "PROTECT" to prevent
writing to the card. Disengage to
enable writing.
• There are also operations you can
perform on memory
cameras/recorders and memory card
recorders that allow you to protect or
enable writing on the card after you
insert it. Read the instructions for the
equipment for details.
• Engage or disengage the switch
before inserting the card into a
memory card drive or computer.
• To prevent malfunction, ensure the
switch is correctly in position.
(h) Memo space (Reverse side)
• Use an oil-based felt pen to write in the
memo space. Erase with a lens
cleaner (the HyperClean EE series
from Olympus is recommended).
Be absolutely sure to check the felt
pen before using it since what is
written by some of these pens cannot
be completely erased.
• Do not use pencil or ballpoint pen as
these can damage the card.
• Do not detach the label on the card or
attach other labels or stickers as these
can cause malfunction.
(i) Serial number bar code (Reverse side)
The serial number is displayed with the
following specifications.
• Type: CODE128
• Narrow width: 0.18 mm
For further details, see the Operating
Instructions for your bar code reader.
(j) Case pocket
You can put a notepad in this pocket.
Specifications
Interface: CardBus (PC card standard)
Capacity: AJ-P2C004HG: approx. 4 GB
AJ-P2C008HG: approx. 8 GB
Recording times: See below
Input voltage: DC 3.3 V ±0.3 V
Power consumption: approx. 1.5 W
Operating temperature: –20 °C to +60 °C
(–4 °F to +140 °F)
Operating humidity:
5 % to 90 % (no condensation)
Storage temperature: –40 °C to +80 °C
(–40 °F to +176 °F)
Storage humidity:
5 % to 90 % (no condensation)
Dimensions (mm):
85.6 (L) X 54 (W) X 5 (D)
(inches: 3.37 (L) X 2.13 (W) X 0.2 (D))
Mass: 45 g (1.6 oz)
• Specifications are subject to change
without notice.
• Mass and dimensions are approximate.
Recording times (approx.)
DVCPRO50, DVCPROHD,
4-channel audio 8-channel audio
8 minutes 4 minutes
16 minutes 8 minutes
･ The recording times shown are when
recording a clip onto a memory card
continuously.
A
1
card
2
3
(c)
B
(e)
(b)
( f ) ( g )
( i )
( h )
( j )
(a)
(d)