Nemaxx SD20B Mode D'emploi page 2

KEN001SD
SD20B SOLAR SHOWER INSTRUCTIONS
Fig. 1
ASSEMBLING INSTRUCTIONS
1. Choose a location for shower which will receive sunlight as
much as can.
2. Mount the shower base to concrete slab or wood base with
four bolts, nuts and gaskets. We recommend to use a
wrench. Fig. 1
3. Attach shower head to extension pipe, then connect
extenson pipe to shower upper tube with adjust nut.
We don't recommend using wrench. Fig. 2
NOTE: Don't forget gasket when connecting the shower
head and extension pipe.
4. Put O-ring on the slot of lower tube. Fig. 3
5. Lift shower upper tube on lower tube. Fig. 3
6. Turn locking ring clockwise to securely connect upper tube to
lower tube. Fig. 3
NOTE: Handle and shower head need to face the same direction.
INITIAL SET UP OF THE SHOWER
1. Turn handle to FULL ON HOT position.
NOTE: Filling water with handle on "full on hot" position
ensures no air pockets are trapped in the shower.
2. Attach garden hose to hose connector. Turn on water supply
to garden hose to fill the shower. It will take 2 to 3 minutes
to fill up.
3. When water flows from shower head, turn the handle off.
Turning the handle off makes the water start heating in tubes.
4. Depending on available sunlight and outside temperature,
the shower will take one to two hours to fully heat the water.
5. Water temperature in shower can reach 60ºC in strong
sunshine.
EN
Fig. 2
2
Gasket
Fig. 3
Version: 4.0
04.05.2017
Extension pipe
Gasket
Adjust
nut
Shower head
Upper tube
Locking ring
Safety locking
0 ring
Handle
Lower tube
Hose connector
Bolts
Washers
Nuts