R82 Wombat Solo Instructions De Montage page 6

Mounting instruction
Mounting the tray
Follow the instructions below to assemble and mount the tray (the
enclosed 5 mm Allen key can be used on all bolts):
1. The tray rods (A) are mounted in the fittings (B) with the enclosed
bolts and washers (C). Please note that rods (A) can be placed on
the left or the right depending on the width required to fit the seat.
Do not tighten the bolts fully at this point. Leaving them loose will
allow for width adjustment as the tray is mounted onto the seat.
2. Depending on the type of seat the handle is flipped up or the finger
screw is loosened on the arm rest rod.
3. Mount the rods from the tray into the tube beneath both arm rests.
4. Depending on the type of seat the tray is fastened by flipping down
the handle or tightening the finger screw on the arm rest rod.
5. The bolts (C) under the tray can now be tightened firmly with the
enclosed Allen key.
The tray can only be mounted on seats equipped with arm rests.
Any adjustments and addition of accessories must be placed
and fitted correctly and checked before every use.
A
C
B