Dometic GROUP WAECO PerfectView CAM60ADR Mode D'emploi page 33

PerfectView CAM60ADR
➤ Align the camera provisorily so that the lens is at an angle of approx. 50°
to the perpendicular axis of the vehicle (fig. d, page 7).
A
NOTICE! Risk of damage!
Never mount the camera without the camera guard.
Connecting the camera
I
NOTE
 Lay the camera cable so that should you need to remove the
camera, you can access the plug connection between the
camera and the extension cable easily. This considerably
eases dismantling work.
 To minimise corrosion in the plug, apply a small amount of
grease – such as pin grease – inside the plug.
 Additional extension cables are available on request
(see "Accessories" on page 27).
➤ Guide the camera cable into the vehicle interior.
➤ Insert the plug of the camera cable into the socket of the extension cable.
➤ Screw on the plug connections of the connecting cables to protect against
water penetration (fig. e, page 7).
Aligning the camera
I
NOTE
If necessary before aligning the camera connect the camera to a
monitor and to a power supply (see connecting diagram, fig. f,
page 7
➤ Use the monitor image to align the camera:
The monitor image should show the bottom edge of the rear or the
bumper of your vehicle (A). The middle of the bumper should be in the
middle of the screen. (fig. g, page 7).
➤ Check the function of the camera after you have connected it to a monitor.
EN
Mounting the camera
33