Dometic GROUP WAECO PerfectView CAM60ADR Mode D'emploi page 26

Safety and installation instructions
 Always follow the safety instructions of the vehicle manu-
facturer.
Some work (e.g. on retention systems such as the AIRBAG etc.)
may only be performed by qualified specialists.
NOTICE!
A
 To prevent damage when drilling, make sure there is sufficient
space on the other side for the drill head to come out.
 Deburr all drill holes and treat them with a rust-protection agent.
Observe the following instructions when working with electrical parts:
NOTICE!
A
 When testing the voltage in electrical cables, only use a diode
test lamp or a voltmeter.
Test lamps with an illuminant take up voltages which are too
high and which can damage the vehicle's electronic system.
 When making electrical connections, ensure that:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp edged ducts without protection.
 Insulate all connections.
 Secure the cables against mechanical wear with cable binders
or insulating tape, for example to existing cables.
The camera is watertight in accordance with IP69K. The seals on the camera
can therefore withstand a high-pressure cleaner. Nevertheless, keep a dis-
tance of at least 50 cm between the nozzle of the high pressure cleaner and
the camera.
Always observe the following instructions when handling the camera:
 Do not open the camera, as this impairs the sealing and the function of
the camera (fig. 4, page 4).
 Do not pull at the cables, as this impairs the sealing and the function of
the camera (fig. 5, page 4).
 The camera is not suitable for submerged operation.
26
PerfectView CAM60ADR
EN