Switched (Daisy Chain) Connection; Redundant Connection - Tascam IF-DA64 Mode D'emploi

Switched (daisy chain) connection

Dante devices can be daisy-chained when there are few
connected devices and when not using a switching hub. Connect
them as shown below.
8 Switched (daisy chain) connection example
IF-DA64 /
Mixer
NOTE
•
When using a switched (daisy chain) connection, connect
to either the PRIMARY or SECONDARY connector.
•
If the number of connected devices increases, raising the
latency setting will be necessary.

Redundant connection

For recording situations where retakes are not possible, including
live performances, a connection set up like the following uses two
completely independent primary and secondary networks.
IF-DA64 /
DA-6400 DA-6400
8 Redundant connection example
Primary
PC
HUB
NOTE
Settings for switched (daisy chain) and redundant
connections do not change automatically. Change the
settings on the Dante Controller Network Config screen.
CAUTION
•
The primary and secondary networks cannot be
connected to each other in any way.
•
Do not connect the primary and secondary networks to
the same switching hub.
Secondary
Primary
Secondary
Mixer
IF-DA64 /
HUB
DA-6400
IF-DA64 /
DA-6400
Hub
TASCAM IF-DA64
9