HEIDENHAIN IK 5000 QUADRA-CHEK Guide D'installation page 21

44-pin D-sub connector: Pin layout
For X, Y, Z axes and foot switch pin layouts
Further Information: "H", page 171.
26-pin D-sub connector: Pin layout
For X, Y, Z CNC pin layouts
Further Information: "I", page 171.
15-pin SATA connector: Pin layout
For SATA power pin layouts
Further Information: "J", page 171.
44-pin D-sub connector: Pin layout
For Q axis pin layouts
Further Information: "K", page 172.
26-pin D-sub connector: Pin layout
For Q CNC pin layouts
Further Information: "L", page 172.
9-pin D-sub connector: Pin layout
For touch probe pin layouts
Further Information: "M", page 172.
44-pin D-sub connector: Pin layout
For light and zoom control pin layouts
Further Information: "N", page 173.
9-pin D-sub connector: Pin layout
For TP-200 touch probe pin layouts
Further Information: "O", page 173.
25-pin D-sub connector: Pin layout
For zoom motor pin layouts
Further Information: "P", page 173.
Optical connector: Layout
For optical light source layout
Further Information: "Q", page 174.
Optical connector: Layout
For optical screen sensor layout
Further Information: "R", page 174.
9-pin D-sub connector: Pin layout
For V.24/RS-232-C pin layout
Further Information: "S", page 174.
HEIDENHAIN | IK 5000 QUADRA-CHEK | 7/2016
4.5 Connecting power
WARNING
Risk of electric shock!
Improper grounding of electrical devices involves a risk
of serious injury or death by electric shock.
Always use 3-wire power cables
Make sure the ground wire is correctly connected to
the ground of the building's electrical installations
WARNING
Fire hazard from the use of power cables that do not
meet the minimum requirements!
Use only power cables that fulfill or exceed the
specified minimum requirements
NOTICE
Electrical machinery or lightning can cause damaging
power line transients.
Connect the PC to power through a high-quality
surge suppressor
For power-up instructions, refer to the PC
manufacturer's Operating Instructions.
Connecting PC power cord
Verify that the PC power switch is in the off position
Verify that the PC power cord is not plugged into the
main power supply
Insert the female end of the PC power cord into the
PC power connector on the rear of the PC
23