Instructions For Use - HammerSmith Bit Pro Mode D'emploi

INSTRUCTIONS FOR USE

The Hammersmith Drill Bit Pro has been designed for drilling materials that cannot be drilled with standard
drill bits, i.e. concrete, brick, ceramic, hardened steel, granite, plastic, wood, marble and glass.
ALWAYS READ THE INSTRUCTIONS BEFORE USE!
SAFETY NOTICES
• A backing plate should be used when drilling.
• The drill bits are extremely sharp, handle them carefully.
• NEVER use the Hammersmith Drill Bit Pro with the hammer drill function of your drill.
This will damage the drill bits. When drilling masonry and concrete, the Hammersmith
Drill Bit Pro are designed to work with the standard function of your drill.
Refer to the table below to ensure that you are using the correct speed, pressure and coolant for the various materials listed.
Material
Glass
Brick
Concrete
Steel
Aluminium
Wood
Ceramic
Plastic
Air = compressed air jet or dry
(no coolant)
M30752_M30749_Hammersmith_Drill_Bit_Pro_Professional_Manual_A5_20211012_BS.indd 3 M30752_M30749_Hammersmith_Drill_Bit_Pro_Professional_Manual_A5_20211012_BS.indd 3
EN
Pressure
Light
Medium
Medium
Heavy
Medium - Heavy
Medium - Heavy
Light
Medium - Heavy
Oil = machining oil (cutting lubricant, CRC, WD40)
3
Speed
Medium
Medium - Low
Medium - Low
Medium
High
High
Medium
Medium - Low
Coolant
Water
Water or air
Water or air
Air or oil
Oil
Air
Water
Water or air
Water = fresh water.
TIP: spray water for cooling
using a spray bottle while
drilling.
Made in China
12.10.21 13:04 12.10.21 13:04