What If There Are Problems; Disposal; Technical Specifications; Warranty / Service - Beurer BY 76 Mode D'emploi

9. What if there are problems?

Fault
The device does not switch on after
the cable is plugged in.
The device switches itself off after
the warming up phase, there are no
more displays.
The device switches itself off mid-
way through the process, and there
are no more displays.
No LED display

10. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end of its useful life.
Dispose of the unit at a suitable local collection or recycling point. Dispose of the device in accordance
with EC Directive – WEEE (Waste Electrical and Electronic Equipment). If you have any questions,
please contact the local authorities responsible for waste disposal.

11. Technical specifications

Model
Dimensions
Weight
Supply voltage
Output
Disinfection time

12. Warranty / Service

Beurer GmbH, Söflinger Straße 218, 89077 Ulm, Germany (hereinafter referred to as "Beurer") provides a
warranty for this product, subject to the requirements below and to the extent described as follows.
The warranty conditions below shall not affect the seller's statutory warranty obligations which
ensue from the sales agreement with the buyer.
The warranty shall apply without prejudice to any mandatory statutory provisions on liability.
Beurer guarantees the perfect functionality and completeness of this product.
The worldwide warranty period is 3 years, commencing from the purchase of the new, unused product
from the seller.
The warranty only applies to products purchased by the buyer as a consumer and used exclusively for
personal purposes in the context of domestic use.
German law shall apply.
Cause
No electricity
No water in the steriliser Unplug the device, allow it to cool
Too little water in the
steriliser
Mains plug not (prop-
erly) plugged in or faulty
device
BY 76
ø x H: ~ 235 x 330 mm
1260 g (including accessories)
220 - 240 V ~ / 50/60 Hz
500 watts
approx. 7 mins
14
Action
Check that the plug is properly plugged
in.
down, then fill it with 120 ml water and
start the programme as described in
the instructions.
Check that the mains plug is (properly)
plugged in. If there is still no display,
switch the device off, unplug it and
return the device to the retailer.