Usage; Cleaning And Maintenance - Beurer BY 76 Mode D'emploi

Before using for the first time, let the sterilisation process run once without any parts to be sterilised. For
this, follow the steps in the 'Operation' section.
If you would like to use the device immediately after the empty process, allow it to cool for at
least 20 minutes after draining the residual water. The same applies to numerous consecutive
uses.

7. Usage

1. Clean the parts that are to be sterilised with mild washing up liquid or in the dishwasher. Disassemble
any assembled parts.
2. Measure 120 ml distilled water (alternatively tap water) and pour it into the sterilisation container.
3. Now place the bottles into the bottle stand with the opening pointing downwards and place the teats or
other small parts in the basket for small parts.
4. Place the bottle stand and the basket for small parts into the sterilisation container.
5. Then put the lid on the device.
6. Plug the mains plug into a socket.
The display shows 0. The device is ready for use.
7. Press the switch to start the sterilisation process.
Once the operating temperature has been reached, the remaining sterilisation time is continuously
shown in the display, starting from 7 minutes.
At the end of the process, a signal sounds. You may now switch the steriliser off.
8. After a cooling down period of at least 5 minutes, carefully open the lid and remove the sterilised parts
using the gripping tongs.
9. Shake the parts to remove any excess water.
Remove the mains cable. Drain the residual water and dry the container with a cloth.
• After the sterilisation process, three bars are shown on the display. This shows that from this
point onwards, the items in the sealed steriliser will remain sterile for up to three hours. The
passage of time is displayed in hourly steps from III to I. After the final hour has passed, 0 is
shown on the display.
• After three hours have passed, the items must be newly sterilised, regardless of whether or
not the device was opened.
• Use the sterilised parts immediately after removal, or else they will require re-sterilising.

8. Cleaning and maintenance

The service life of the device depends on careful use:
• Use distilled water for the sterilisation.
• Unplug the device before cleaning.
• To clean the device, use only a damp cloth. Do not use any scouring agents or other cleaning
products.
• Descale the device using vinegar or citric acid. Descale the device with vinegar or citric acid. Mix 50
ml white vinegar with 100 ml cold water or a packet of citric acid with 200 ml cold water and pour
the solution into the device. Leave the solution to work until the lime scale has been removed; do not
operate the device during this time. Pour the liquid away, rinse the device out thoroughly and finally dry
it with a cloth.
• Descale the device approx. every four weeks.
13