Chillafish CPSS01 Guide D'utilisation page 4

INSTRUCTIONS FOR USE WITH HANDLEBAR – SCOOTER MODE
• Check and secure all fasteners and all locking mechanisms for the handlebar before and after every ride.
• Put your hands at the handlebar and position one foot on the deck and place the other foot on the ground to start moving forward. To stop moving
remove one foot from the deck to the floor and stop moving.
• There is no braking system. You have to get off the board before it goes too fast.
• Learn everything slowly, including new tricks. When losing balance don't wait until you fall, step off and start again. Ride down gentle slopes at first.
Then ride slopes where your speed is only so fast you can still get off the board without falling.
• Most serious injuries are broken bones so learn to fall (by rolling if possible) without the board first.
• Users starting to learn how to scoot need to try with a friend or parent.
• Before you jump off the board watch where it may go, it could injure someone else.
• Before and after use, remove any sharp edges created through use.
• To steer put your foot on the rough surface and keep your weight on the right and/or on the left side. Hold the handlebar with your hands.
• Make sure the product is ready for use like indicated in the instruction manual in order to avoid any pitching or entrapment.
INSTRUCTIONS FOR USE WITHOUT HANDLEBAR – SKATEBOARD MODE
• Position one foot on the deck and place the other foot on the ground to start moving forward. To stop moving remove one foot from the deck to the
floor and stop moving.
• There is no braking system. You have to get off the board before it goes too fast.
• Learn everything slowly, including new tricks. When losing balance don't wait until you fall, step off and start again. Ride down gentle slopes at first.
Then ride slopes where your speed is only so fast you can still get off the board without falling.
• Most serious skateboard injuries are broken bones so learn to fall (by rolling if possible) without the skateboard first.
• Skateboarders starting to learn how to skate need to try with a friend or parent.
• Before you jump off the board watch where it may go, it could injure someone else.
• Before and after use, remove any sharp edges created through use.
• To steer put your foot on the rough surface and keep your weight on the right and/or on the left side.
• Make sure the product is ready for use like indicated in the instruction manual in order to avoid any pitching or entrapment.
INSTRUCTIONS FOR ASSISTANCE AND MAINTENANCE
• Check periodically all parts that can wear out or can cause falling or overturning.
• Replace damaged parts, wheels, bearings etc.
• The equipped bearings need regular maintenance, always clean them and remember to keep them regularly lubricated.
• Remove any sharp edges or chips caused by usage of the product.
• If during prolonged use or after some serious damage deep cracks develop, cease all use of the skateboard and substitute the board.
• Regular maintenance increases the safety of the equipment.
2