ORILUX THP04N Mode D'emploi page 47

Failure code
Failure
NO. Failure description
code
1 EE 1 High pressure protection
2 EE 2 Low pressure protection
3 EE 3 Low water pressure protection
failure connection due to loose wire terminal
4 EE 4
of PROT2 on the PC board
5 PP 1 Pool water temp sensor failure
6 PP 2 Heat only type : Exhaust temp sensor failure
7 PP 3 Heating coil pipe temp sensor failure
8 PP 4 Gas return temp sensor failure
9 PP 5 Air temp sensor failure
10 PP 6 Compressor exhaust overload protection
When the temperature ＜ 0℃,auto stop for
11 PP 7
protection (Not Failure )
EE8/888
12 /Messy Communication Failures
Code
Action
Contact your dealer.
Contact your dealer.
1. Check if there is no water
through the machine; make
sure the pump is on.
2. Or contact your dealer.
Contact your dealer.
Contact your dealer.
Contact your dealer.
Contact your dealer.
Contact your dealer.
Contact your dealer.
Contact your dealer.
Machine Auto-protection
Contact your dealer.
45