Precautions - ORILUX THP04N Mode D'emploi

suitable temperature in the thermostat, and then switch on power supply;
C．In order to protect the swimming pool heater, the machine is equipped with a
time lag starting function, when starting the machine, the blower will run 1
minutes earlier than the compressor;
D．After the swimming pool heater starts up, check for any abnormal noise from
the machine.
VIII. Precautions
1. Attention
A. Set proper temperature in order to get comfortable water temperature; to avoid
overheating or overcooling;
B. Please don't stack substances that can block air flow near inlet or outlet area, or
the efficiency of the heater will be reduced or even stopped;
C. Please don't put hands into outlet of the swimming pool heater, and don't
remove the screen of the fan at any time;
D. If there are abnormal conditions such as noise, smell, smoke and electrical
leakage, please switch off the machine immediately and contact the local
dealer. Don't try to repair it yourself;
E. Don't use or stock combustible gas or liquid such as thinners, paint and fuel to
avoid fire;
F. In order to optimize the heating effect, please install heat preservation insulation
on pipes between swimming pool and the heater. During running period of the
swimming pool heater, please use a recommended cover on the swimming
pool;
G . Connecting pipes of the swimming pool and the heater should be ≤10m, or the
heating effect of the heater cannot be ensured;
H. This series of machines can achieve high efficiency under air temperature of
+15℃～+25℃.
2. Safety
A．Please keep the main power supply switch far away from the children;
B． When a power cut happens during running, and later the power is restored, the
heater will start up automatically. So please switch off the power supply
42