Table des Matières
Publicité
English
10
Note: Do not clean more than one cutter and shaving guard at a time, since they are all matching sets. If you accidentally put a cutter in the wrong
shaving guard, it may take several weeks before optimal shaving performance is restored.
5
Clean the cutter with the cleaning brush supplied (Fig. 40).
6
Clean the inside of the shaving guard. (Fig. 41)
7
After cleaning, place the cutter back into the shaving guard with the cutter legs pointing downwards. (Fig. 42)
8
Place the retaining frame back onto the shaving head holder. (Fig. 43)
9
Slide the guard back into place ('click'). (Fig. 44)
10
Reattach the shaving head holder to the bottom part of the shaving unit. (Fig. 27)
cleaning the trimmer
Clean the trimmer every time you have used it.
1
Switch on the shaver with the trimmer attached.
2
Rinse the trimmer under a hot tap for some time. (Fig. 45)
3
After cleaning, switch off the shaver.
Tip: For optimal trimmer performance, lubricate the trimmer teeth with a drop of sewing machine oil every six months.
storage
1
Slide the protection cap onto the shaving unit to prevent damage to the shaving heads (Fig. 46).
2
Specific types only: Store the shaver in the pouch supplied.
Replacement
For maximum shaving performance, we advise you to replace the top part of the shaving unit every year.
Only replace the top part of the shaving unit with an original RQ11 Philips Shaving Head Holder.
1
Pull the shaving head holder off the bottom part of the shaving unit (Fig. 26).
2
Attach the new shaving head holder to the bottom part of the shaving unit ('click') (Fig. 27).
ordering parts
The following parts are available:
-
HQ8505 adapter
-
RQ11 Philips Shaving Head Holder
-
HQ110 Philips Shaving Head Cleaning Spray
-
HQ200 Philips Cleaning Fluid
Environment
-
Do not throw away the appliances with the normal household waste at the end of their life, but hand them in at an official collection point
for recycling. By doing this, you help to preserve the environment (Fig. 47).
-
The built-in rechargeable shaver battery contains substances that may pollute the environment. Always remove the battery before you
discard or hand in the shaver at an official collection point. Dispose of the battery at an official collection point for batteries. If you have
trouble removing the battery, you can also take the appliance to a Philips service centre. The staff of this centre will remove the battery for
you and will dispose of it in an environmentally safe way (Fig. 48).
Removing the rechargeable shaver battery
Only remove the rechargeable battery when you discard the shaver. Make sure the battery is completely empty when you remove it.
Be careful, the battery strips are sharp.
1
Remove the back panel of the shaver with a screwdriver.
2
Remove the rechargeable battery.
guarantee and service
If you need service or information or if you have a problem, please visit the Philips website at www.philips.com or contact the Philips
Consumer Care Centre in your country (you find its phone number in the worldwide guarantee leaflet). If there is no Consumer Care Centre
in your country, go to your local Philips dealer.
guarantee restrictions
The shaving heads (cutters and shaving guards) are not covered by the terms of the international guarantee because they are subject to wear.
troubleshooting
This chapter summarises the most common problems you could encounter with the appliance. If you are unable to solve the problem with the
information below, contact the Consumer Care Centre in your country.
Problem
The shaver does not shave as
well as it used to.
Possible cause
The shaving heads are damaged or worn.
Solution
Replace the shaving head holder (see chapter
'Replacement').
Publicité
Table des Matières
