Remington HyperFlex XR1330 Mode D'emploi page 4

ENGLISH
C GETTING STARTED
For best shaving performance, it is recommended that you use your new shaver
daily for up to four weeks to allow time for your beard and skin to become
accustomed to the new shaving system.
, CHARGING YOUR SHAVER
• Ensure the appliance is turned off.
• Connect the charging stand to the adaptor and then to the mains.
• Place the shaver in the charging stand.
• Charge for at least 24 hours when using for the first time.
• Allow 90 minutes for a full charge (XR1350 and XR1370) and 4 hours for XR1330.
The charging indicator light (XR1330), fuel gauge (XR1350) or LCD display
(XR1370) will indicate when the shaver is fully charged.
• To preserve the life of your batteries, let them run out every 6 months then
recharge for 24 hours.
• The shaver automatically adjusts to a mains voltage between 100V and 240V.
O This appliance should be charged by approved safety isolating adaptors
PA-0510E(K) with the output capacity of 5.0 dc; 1.0A.
F INSTRUCTIONS FOR USE
, SHAVING
Note: This shaver is for cordless use only.
• Make sure your shaver is properly charged.
• Switch the shaver on.
• Stretch the skin with your free hand so the hairs stand upright
• Only apply light pressure on the shaving head while shaving (pressing too hard
can damage the heads and make them vulnerable to breakage).
• Use short, circular strokes.
, SHAVING WITH SHAVING GEL
• Follow the same instructions as dry shaving if using with gel.
F CAUTION: After use with shaving gel, please rinse the head and cutters under
warm water to clean away any excess gel and debris.
, TRIMMING
• Push the trimmer button to release the detail trimmer.
• Hold the trimmer at right angles to the skin.
4