ACIS Vipool Manuel De L'utilisateur page 8

FILTRES BOBINES SIDE
SIDE FIBERGLASS FILTERS
3.3 CONNECTION
▪ Connect the valve to the pump by the opening PUMP
▪ Connect the outlet towards the swimming-pool by the opening RETURN and then finish the connections (swimming-pool
-> pump, valve -> drain)
8
3.4 CHECKS
Check that everything has been correctly tightened. ATTENTION to all unions with o'ring, do not use sealants (teflon, ...).
Tightened by hand only.
5. COMMISSIONING
Cut off the electricity supply.
▪ Press down hard on the handle of the 6-way valve, and then place it in line with the indicator WASH (in order to avoid
damaging the joint, always press down hard on the handle before turning it).
▪ Activate the pump and allow the water to run towards the drain for approximately one minute, this initial wash cleans
the sand and removes any impurities.
▪ Stop the pump, and then set the 6-way valve to the position RINSE. Then start the pump and let it run for about 30
seconds,
▪ Stop the pump, and then re-set the 6-way valve to the position FILTRATION. Then re-start the pump.
▪ If required, adjust the delivery valve in order to obtain the required flow rate.
▪ Check the installation to ensure that there are no leaks.
▪ Take a note of the pressure shown on the pressure gauge when the filter is clean. The pressure increases as the sand gets
dirty: Once the pressure has risen by about 0.4 bars, wash the filter in line with the instructions above.
N.B.: When preparing the swimming pool for activity after a winter break, it may be necessary to launch a back-wash
procedure more frequently.
15 Rue des Marais 44310 ST Philbert de Gd Lieu – Tel. 02 40 59 95 35 – www.acis-france.com