Removing The Prismapsg Module; Scaling On The Psg System - Weinmann prismaPSG Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. If necessary: Switch on the therapy device.
Result
prismaPSG is connected
The green

4.2 Removing the prismaPSG module

1. Disconnect the connector of the PSG connection cable from
the module interface on the prismaCONNECT module.
Result
The module is removed.
The gray symbol

4.3 Scaling on the PSG system

The prismaPSG module has 8 analog connection sockets. These are
assigned set parameters:
Analog
output
socket
1
2
3
4
5
6
7
8
1
In firmware Version 1.x, signals are not yet available and are displayed as
zero lines.
The analog output signals deliver a voltage of 0 to 1 V.
To label the assignment of the channels, cut out one of the strips
of paper from the last page of these instructions and insert it in
the front panel membrane of the module prismaPSG.
symbol appears on the therapy device display.
appears on the therapy device display.
Signal
Respiratory flow
Leak flow
Degree of obstruction
Setpoint pressure
Actual pressure
1
RMV
1
Tidal volume
Respiratory frequency
4 Preparation and operation
Lower phys.
Upper phys.
limit
limit
-250 l/min
250 l/min
0 l/min
100 l/min
0 %
0 hPa
0 hPa
0 l/min
0 ml
0 bpm
prismaPSG
100 %
40 hPa
40 hPa
63 l/min
2000 ml
63 bpm
EN
31

Publicité

Table des Matières
loading

Table des Matières