NuTone InVent ARN80RB Mode D'emploi page 4

NEW CONSTRUCTION
For Retrofit Installation - Skip to Page 5.
4. Attach damper/duct connector
to fan housing.
Push connector through opening from inside of housing.
Engage tabs and secure with screw from parts bag.
TABS
5. Mount housing to ceiling
structure.
Make sure bottom of housing will be flush with finished
ceiling.
For proper location using ½" ceiling material: Bend out
housing tabs to fit against bottom of structure.
Secure housing through mounting ears with
appropriate fasteners.
If mounting housing to I-joist, use wood blocking as
shown.
4
HOUSING
TABS
6. Connect 4-in. round duct.
7. Connect wiring.
Bend tab to expose desired access hole. Connect
power cable to housing with appropriate UL approved
connector. Connect black to black, white to white and
green to green or bare wire. Re-install wiring panel and
secure with screw from parts bag.