Automatic Search With New / Other Satellite - Berger 359320 Manuel D'utilisation

EN
AUTOMATIC SEARCH WITH NEW / OTHER SATELLITES
Select the main menu.
Select automatic search and press ENTER to enter the submenu.
Press ENTER again.
Satellite: Use the buttons to select the desired satellite.
Channel Type: Use the keys to select whether you want to receive „All" channels or only
„Free" or only „Scrambled" channels.
Service Type: Use the keys to select whether you want to search for and save radio, TV or
all channels.
Search Mode: Press the key to select the search mode (Preset, Auto, Blind Scan). Normally
it is Blind Scan.
Preset loads the preset station list from the factory.
Use the keys to select the menu item „Search" and press the „ENTER" key to start the
search.
40
DVB-T2 SEARCH
Channel search for DVB-T / T2 and DVB-C (recommended procedure also for countries such as
the Czech Republic, Slovenia, etc.)
Key Source, change to Antenna
Before a search in DVB-T / T2 mode, you should switch on the 5V antenna voltage in the main
menu. Most antennas require this setting.
It is recommended to select the setting OFF in the line LCN.
LCN means automatic pre-sorting, but it does not work in Germany, so it is recommended to
re-sort manually.
Select DTV and Germany with the right arrow key.
EN
41